Stelpro Electric Baseboard Heaters Windsor, Ontario
Stelpro Brava In Stock at MarsLED
Windsor, Ontario • Electric Heating
Stelpro Electric Baseboard Heaters in Windsor
Shop stocked Stelpro Brava electric baseboard heaters for Windsor homes, rental properties, additional dwelling units, basement renovations, contractor projects and property-management applications. MarsLED carries 120 V and 240/208 V Brava models plus compatible built-in thermostat options.
Stelpro Brava Windsor
Electric baseboard heating for Windsor homes and projects.
Electric baseboard heating can be a practical option in Windsor homes, rental units, additional dwelling units and renovation projects where the electrical and heating design calls for electric resistance heat. Stelpro Brava heaters provide multiple wattage and voltage configurations for project-specific selection.
Stelpro identifies Brava for bedrooms, dining rooms, living rooms and offices. Its rounded corners, one-piece rugged casing and installer-friendly design also make the platform useful for replacement work and ongoing property maintenance.
Why Brava?
Brava combines low-profile electric convection heat with the durability and clean appearance needed for residential and appropriate light-commercial environments.
- Rounded-corner design
- Rugged one-piece steel casing
- Quiet heating-element design
- Multiple wattage and voltage options
- Optional built-in thermostat control
Windsor property-standards context
Windsor's current Property Standards By-law requires 22°C in tenant accommodation.
Windsor's current Property Standards By-law requires every dwelling and dwelling unit to have a heating system maintained in good repair and safe operating condition. For the purposes of that by-law, adequate and suitable heat means a minimum air temperature of 22°C in accommodation available to a tenant or lessee.
The same by-law requires heating systems, appliances, pumps and filtration equipment to remain safely operable, and it prohibits portable heating equipment from serving as the primary source of heat in a dwelling unit. Common areas and internal entrance ways in multiple dwellings must have heating systems capable of maintaining at least 18°C.
Stocked at MarsLED
Compare Stelpro Brava baseboard heaters.
Choose from the stocked MarsLED Brava range below. Heater selection should be based on the project's calculated heating load, voltage, circuit requirements, dimensions, clearances and applicable electrical requirements—not wattage or room size alone.
| Model | Power | Voltage | Length | Shop |
|---|---|---|---|---|
| B0501W | 500 W | 120 V | 27-7/8" | View B0501W |
| B0751W | 750 W | 120 V | 37-5/8" | View B0751W |
| B1001W | 1000 W | 120 V | 47-1/2" | View B1001W |
| B0502W | 500 / 375 W | 240 / 208 V | 27-7/8" | View B0502W |
| B0752W | 750 / 560 W | 240 / 208 V | 37-5/8" | View B0752W |
| B1002W | 1000 / 750 W | 240 / 208 V | 47-1/2" | View B1002W |
| B1502W | 1500 / 1125 W | 240 / 208 V | 66-1/4" | View B1502W |
| B2002W | 2000 / 1500 W | 240 / 208 V | 83-7/8" | View B2002W |
Electrical selection
120 V or 240/208 V? Match the heater to the project.
Voltage must match the electrical design and circuit serving the heater. When replacing an existing baseboard or planning a new installation, confirm voltage, wattage, circuit capacity and installation conditions before ordering.
B0501W • B0751W • B1001W
MarsLED stocks three 120 V Brava models from 500 W through 1000 W for projects designed around 120 V electric baseboard heating.
500 W through 2000 W
The stocked 240/208 V Brava range includes five models. Output is lower at 208 V, so both ratings are shown on the individual product pages.
Windsor application guide
Where Brava fits into Windsor projects.
Brava heaters can support a wide range of projects when electric resistance baseboard heat is appropriate for the building and the heater is correctly specified.
Replacement or new electric heating in bedrooms, living areas, offices, basements and additions.
Heating for permitted basement, internal or accessory-building ADU projects where electric baseboard heat is part of the approved electrical and heating design.
Replacement and maintenance work in electrically heated rented residential units.
Stocked heater options for ongoing building maintenance, renovation and replacement programs.
Multiple wattage and voltage options for properly specified installation and retrofit work.
A familiar electric-heating platform for renovation, addition and residential construction projects.
Additional dwelling units in Windsor
Windsor permits up to three total dwelling units on qualifying residential parcels.
Windsor uses the term Additional Dwelling Unit (ADU) for a separate self-contained residential unit located within a qualifying dwelling or within an accessory building on the same lot. The City also notes that ADUs may be known as second units, accessory or basement apartments, secondary suites, carriage houses, laneway suites and in-law flats.
Current City guidance allows a total of three units on qualifying urban residential parcels containing a single-detached, semi-detached or street-townhouse dwelling. The three units may all be located in the main building, or two may be located in the main building with one additional unit in an accessory building.
Windsor requires a building permit for any ADU. Basement ADUs are prohibited in floodplain areas. Outside floodplain areas, basement units may be permitted where specified flood-protection measures such as downspout disconnection, a sump pump and applicable backflow protection are addressed.
If electric baseboard heating forms part of the approved project design, confirm heating load, voltage, wattage, circuit capacity, clearances and installation requirements before ordering.
Windsor ADU considerations
- Confirm zoning and dwelling-type eligibility
- Confirm the proposed configuration stays within the three-unit total
- Obtain the required building permit before construction
- Review floodplain restrictions before planning a basement ADU
- Address required basement-flooding protection measures where applicable
- Match heater voltage and wattage to the approved electrical and heating design
Built-in temperature control
Complete the Brava installation with a Stelpro thermostat.
MarsLED stocks both built-in mechanical thermostat options. Compatibility and the correct control type should be confirmed for the specific heater and project before installation.
Single-Pole Built-In Thermostat
Mechanical 120–600 V built-in temperature control for compatible Stelpro baseboard heater installations.
View SIBT1WDouble-Pole Built-In Thermostat
Mechanical 120–600 V double-pole built-in thermostat for compatible Stelpro baseboard heater installations.
View SIBT2WWindsor product questions
Stelpro baseboard heater FAQ — Windsor
Where can I buy Stelpro Brava baseboard heaters for a Windsor, Ontario project?
MarsLED stocks multiple Stelpro Brava 120 V and 240/208 V electric baseboard heaters for Windsor homeowners, contractors, electricians, landlords and property-management customers.
What minimum heat does Windsor's current Property Standards By-law require for tenant accommodation?
For the purposes of Windsor's current Property Standards By-law, adequate and suitable heat means a minimum air temperature of 22°C in accommodation available to a tenant or lessee.
What heating capability is required in common areas of Windsor multiple dwellings?
Windsor's current Property Standards By-law requires common areas and internal entrance ways in multiple dwellings to have heating systems capable of maintaining at least 18°C.
Can portable heaters be the primary heat source in a Windsor dwelling unit?
No. Windsor's current Property Standards By-law states that portable heating equipment cannot serve as the primary source of heat in a dwelling unit.
Can Stelpro baseboard heaters be used in a Windsor additional dwelling unit?
They can be considered where the permitted ADU's approved electrical and heating design calls for compatible electric baseboard heating. Heater selection should follow the project's zoning, building-permit, electrical and heating requirements.
How many dwelling units can Windsor permit on a qualifying residential parcel?
Windsor's current ADU framework allows a total of three dwelling units on qualifying urban residential parcels containing specified low-rise dwelling types, subject to applicable requirements.
Can a Windsor ADU be located in an accessory building?
Yes. Windsor allows a configuration with two units in the main building and one unit in an accessory building, subject to applicable zoning and site requirements.
Can a basement be used for an ADU in Windsor?
Outside floodplain areas, a basement ADU may be permitted where the City's specified requirements are met. Basement ADUs are prohibited in floodplain areas.
Does a Windsor ADU require a building permit?
Yes. The City of Windsor states that a building permit is required for any Additional Dwelling Unit.
Can I replace an old baseboard heater with a Brava model of the same wattage?
Not automatically. Confirm voltage, circuit requirements, calculated heating load, dimensions, clearances and installation requirements before choosing a replacement.
Should I buy a 120 V or 240 V baseboard heater?
The heater voltage must match the electrical design of the project. Confirm the existing circuit or project requirements before ordering.
Does MarsLED supply Stelpro heaters for contractor and property-management projects in Windsor?
Yes. MarsLED's stocked Brava portfolio is available for residential, renovation, rental-property, contractor and property-management projects in Windsor and Windsor-Essex, subject to product availability.
Can a built-in thermostat be added to a Stelpro Brava heater?
Compatible Brava installations can use optional built-in thermostat controls. MarsLED stocks the Stelpro SIBT1W single-pole and SIBT2W double-pole thermostat options.
Shop Stelpro Brava heaters for Windsor projects.
Compare stocked wattages, voltages and thermostat options from MarsLED.