Stelpro Electric Baseboard Heaters Richmond Hill, Ontario
Stelpro Brava In Stock at MarsLED
Richmond Hill, Ontario • Electric Heating
Stelpro Electric Baseboard Heaters in Richmond Hill
Shop stocked Stelpro Brava electric baseboard heaters for Richmond Hill homes, rental properties, additional residential units, renovations, contractor projects and property-management applications. MarsLED carries 120 V and 240/208 V Brava models plus compatible built-in thermostat options.
Stelpro Brava Richmond Hill
Electric baseboard heating for Richmond Hill homes and projects.
Electric baseboard heating can be a practical option in Richmond Hill homes, rental units, secondary suites and renovation projects where the electrical and heating design calls for electric resistance heat. Stelpro Brava heaters provide multiple wattage and voltage configurations for project-specific selection.
Stelpro identifies Brava for bedrooms, dining rooms, living rooms and offices. Its rounded corners, one-piece rugged casing and installer-friendly design also make the platform useful for replacement work and ongoing property maintenance.
Why Brava?
Brava combines low-profile electric convection heat with the durability and clean appearance needed for residential and appropriate light-commercial environments.
- Rounded-corner design
- Rugged one-piece steel casing
- Quiet heating-element design
- Multiple wattage and voltage options
- Optional built-in thermostat control
Richmond Hill property-standards context
Richmond Hill requires residential heating systems capable of maintaining 20°C.
Richmond Hill's current Property Standards By-law requires heating and ventilation systems in dwellings to be constructed, installed and maintained in good working order. Every dwelling and dwelling unit must have a heating system capable of maintaining at least 20°C in habitable rooms, bathrooms and toilet rooms.
The by-law also states that a dwelling unit, including a rental unit, cannot use a portable heating appliance as its primary source of heat. For properties designed around electric resistance heating, maintaining properly specified permanent heating equipment is therefore an important part of property upkeep.
Stocked at MarsLED
Compare Stelpro Brava baseboard heaters.
Choose from the stocked MarsLED Brava range below. Heater selection should be based on the project's calculated heating load, voltage, circuit requirements, dimensions, clearances and applicable electrical requirements—not wattage or room size alone.
| Model | Power | Voltage | Length | Shop |
|---|---|---|---|---|
| B0501W | 500 W | 120 V | 27-7/8" | View B0501W |
| B0751W | 750 W | 120 V | 37-5/8" | View B0751W |
| B1001W | 1000 W | 120 V | 47-1/2" | View B1001W |
| B0502W | 500 / 375 W | 240 / 208 V | 27-7/8" | View B0502W |
| B0752W | 750 / 560 W | 240 / 208 V | 37-5/8" | View B0752W |
| B1002W | 1000 / 750 W | 240 / 208 V | 47-1/2" | View B1002W |
| B1502W | 1500 / 1125 W | 240 / 208 V | 66-1/4" | View B1502W |
| B2002W | 2000 / 1500 W | 240 / 208 V | 83-7/8" | View B2002W |
Electrical selection
120 V or 240/208 V? Match the heater to the project.
Voltage must match the electrical design and circuit serving the heater. When replacing an existing baseboard or planning a new installation, confirm voltage, wattage, circuit capacity and installation conditions before ordering.
B0501W • B0751W • B1001W
MarsLED stocks three 120 V Brava models from 500 W through 1000 W for projects designed around 120 V electric baseboard heating.
500 W through 2000 W
The stocked 240/208 V Brava range includes five models. Output is lower at 208 V, so both ratings are shown on the individual product pages.
Richmond Hill application guide
Where Brava fits into Richmond Hill projects.
Brava heaters can support a wide range of projects when electric resistance baseboard heat is appropriate for the building and the heater is correctly specified.
Replacement or new electric heating in bedrooms, living areas, offices, basements and additions.
Heating for permitted ARU projects where electric baseboard heat is part of the approved electrical and heating design.
Replacement and maintenance work in electrically heated rented residential units.
Stocked heater options for ongoing building maintenance, renovation and replacement programs.
Multiple wattage and voltage options for properly specified installation and retrofit work.
A familiar electric-heating platform for renovation, addition and residential construction projects.
Additional residential units in Richmond Hill
ARU projects require permits, heat-load calculations and proper electrical planning.
Richmond Hill permits additional residential units (ARUs), subject to zoning requirements, restrictions and a building permit. An ARU can be located within a main residential building—such as a detached house, semi-detached house or townhouse—and/or in a separate building on the same property.
Under the City's current ARU rules, up to three additional residential units may be permitted in addition to the primary dwelling, provided applicable restrictions are met and the total number of dwelling units on the lot does not exceed four. Richmond Hill's permit guidance also calls for mechanical drawings and heat-loss/heat-gain calculations for newly proposed ARUs, while electrical work requires a separate ESA permit.
Richmond Hill ARU considerations
- Confirm zoning eligibility and applicable restrictions
- Obtain the required building permit
- Prepare required mechanical and design documentation
- Complete heat-loss and heat-gain calculations
- Obtain the required ESA electrical permit
- Match heater voltage, wattage and circuit design to the approved project
Built-in temperature control
Complete the Brava installation with a Stelpro thermostat.
MarsLED stocks both built-in mechanical thermostat options. Compatibility and the correct control type should be confirmed for the specific heater and project before installation.
Single-Pole Built-In Thermostat
Mechanical 120–600 V built-in temperature control for compatible Stelpro baseboard heater installations.
View SIBT1WDouble-Pole Built-In Thermostat
Mechanical 120–600 V double-pole built-in thermostat for compatible Stelpro baseboard heater installations.
View SIBT2WRichmond Hill product questions
Stelpro baseboard heater FAQ — Richmond Hill
Where can I buy Stelpro Brava baseboard heaters for a Richmond Hill project?
MarsLED stocks multiple Stelpro Brava 120 V and 240/208 V electric baseboard heaters for Richmond Hill homeowners, contractors, electricians, landlords and property-management customers.
What heating temperature does Richmond Hill's Property Standards By-law require?
Richmond Hill requires every dwelling and dwelling unit to have a heating system capable of maintaining at least 20°C in habitable rooms, bathrooms and toilet rooms.
Can a portable heater be the primary heat source in a Richmond Hill rental unit?
No. Richmond Hill's current Property Standards By-law states that a dwelling or dwelling unit, including a rental unit, cannot be equipped with a portable heating appliance as its primary source of heat.
Can Stelpro baseboard heaters be used in a Richmond Hill additional residential unit?
They can be considered where the permitted ARU's approved electrical and heating design calls for compatible electric baseboard heating. Heater selection should follow the project's heat-loss calculations, permit documents, electrical design and installation requirements.
How many additional residential units can Richmond Hill permit?
Under Richmond Hill's current ARU rules, up to three additional residential units may be permitted in addition to the primary dwelling, subject to zoning restrictions and a maximum total of four dwelling units on the lot.
Does a new Richmond Hill ARU require heating calculations?
The City's current building-permit guidance for newly proposed ARUs includes mechanical drawings with an Energy Efficiency Design Summary and heat-loss and heat-gain calculations.
Can I replace an old baseboard heater with a Brava model of the same wattage?
Not automatically. Confirm voltage, circuit requirements, calculated heating load, dimensions, clearances and installation requirements before choosing a replacement.
Should I buy a 120 V or 240 V baseboard heater?
The heater voltage must match the electrical design of the project. Confirm the existing circuit or project requirements before ordering.
Does MarsLED supply Stelpro heaters for contractor and property-management projects in Richmond Hill?
Yes. MarsLED's stocked Brava portfolio is available for residential, renovation, rental-property, contractor and property-management projects, subject to product availability.
Can a built-in thermostat be added to a Stelpro Brava heater?
Compatible Brava installations can use optional built-in thermostat controls. MarsLED stocks the Stelpro SIBT1W single-pole and SIBT2W double-pole thermostat options.
Shop Stelpro Brava heaters for Richmond Hill projects.
Compare stocked wattages, voltages and thermostat options from MarsLED.