Stelpro Electric Baseboard Heaters Owen Sound, Ontario
Stelpro Brava In Stock at MarsLED
Owen Sound, Ontario • Electric Heating
Stelpro Electric Baseboard Heaters in Owen Sound
Shop stocked Stelpro Brava electric baseboard heaters for Owen Sound homes, rental properties, additional residential units, basement renovations, contractor projects and property-management applications. MarsLED carries 120 V and 240/208 V Brava models plus compatible built-in thermostat options.
Stelpro Brava Owen Sound
Electric baseboard heating for Owen Sound homes and projects.
Electric baseboard heating can be a practical option in Owen Sound homes, rental units, additional residential units and renovation projects where the electrical and heating design calls for electric resistance heat. Stelpro Brava heaters provide multiple wattage and voltage configurations for project-specific selection.
Stelpro identifies Brava for bedrooms, dining rooms, living rooms and offices. Its rounded corners, one-piece rugged casing and installer-friendly design also make the platform useful for replacement work and ongoing property maintenance.
Why Brava?
Brava combines low-profile electric convection heat with the durability and clean appearance needed for residential and appropriate light-commercial environments.
- Rounded-corner design
- Rugged one-piece steel casing
- Quiet heating-element design
- Multiple wattage and voltage options
- Optional built-in thermostat control
Owen Sound property-standards context
Owen Sound requires dwelling heating systems capable of maintaining 20°C under its Property Standards By-law.
Owen Sound's consolidated Property Standards By-law requires every dwelling to have a heating system capable of maintaining a room temperature of 20°C in all habitable rooms, bathrooms and toilet rooms when the outdoor temperature is -21°C. The temperature is measured one metre above floor level and at least one metre from exterior walls.
Owen Sound also has a Heat By-law for rented or leased living accommodation where heat is normally provided by the landlord. From September 15 through May 31, that by-law defines adequate heat as an air temperature consistently not less than 21°C. For properties designed around electric resistance heating, properly specified permanent baseboard heaters can support replacement, renovation and rental-property maintenance work.
Stocked at MarsLED
Compare Stelpro Brava baseboard heaters.
Choose from the stocked MarsLED Brava range below. Heater selection should be based on the project's calculated heating load, voltage, circuit requirements, dimensions, clearances and applicable electrical requirements—not wattage or room size alone.
| Model | Power | Voltage | Length | Shop |
|---|---|---|---|---|
| B0501W | 500 W | 120 V | 27-7/8" | View B0501W |
| B0751W | 750 W | 120 V | 37-5/8" | View B0751W |
| B1001W | 1000 W | 120 V | 47-1/2" | View B1001W |
| B0502W | 500 / 375 W | 240 / 208 V | 27-7/8" | View B0502W |
| B0752W | 750 / 560 W | 240 / 208 V | 37-5/8" | View B0752W |
| B1002W | 1000 / 750 W | 240 / 208 V | 47-1/2" | View B1002W |
| B1502W | 1500 / 1125 W | 240 / 208 V | 66-1/4" | View B1502W |
| B2002W | 2000 / 1500 W | 240 / 208 V | 83-7/8" | View B2002W |
Electrical selection
120 V or 240/208 V? Match the heater to the project.
Voltage must match the electrical design and circuit serving the heater. When replacing an existing baseboard or planning a new installation, confirm voltage, wattage, circuit capacity and installation conditions before ordering.
B0501W • B0751W • B1001W
MarsLED stocks three 120 V Brava models from 500 W through 1000 W for projects designed around 120 V electric baseboard heating.
500 W through 2000 W
The stocked 240/208 V Brava range includes five models. Output is lower at 208 V, so both ratings are shown on the individual product pages.
Owen Sound application guide
Where Brava fits into Owen Sound projects.
Brava heaters can support a wide range of projects when electric resistance baseboard heat is appropriate for the building and the heater is correctly specified.
Replacement or new electric heating in bedrooms, living areas, offices, basements and additions.
Heating for permitted basement, interior, addition or accessory-building ARU projects where electric baseboard heat is part of the approved electrical and heating design.
Replacement and maintenance work in electrically heated rented residential units.
Stocked heater options for ongoing building maintenance, renovation and replacement programs.
Multiple wattage and voltage options for properly specified installation and retrofit work.
A familiar electric-heating platform for renovation, addition and residential construction projects.
Additional residential units in Owen Sound
Owen Sound permits up to two ARUs per qualifying lot.
Owen Sound uses the term Additional Residential Unit (ARU). The City's current framework permits a maximum of two additional residential units per qualifying lot where a single-detached, semi-detached or townhouse dwelling is permitted, subject to applicable zoning and property requirements.
A maximum of one ARU may be located in an accessory building on the lot. The City's ARU guidance illustrates several possible configurations, including basement apartments, units incorporated into or added to a primary dwelling, and units in detached accessory structures.
A building permit is required for an ARU. Owen Sound's Building Division also identifies heat-loss/heat-gain calculations among the documentation required for major residential construction and renovation applications. Legal ARUs must comply with applicable Ontario Building Code, electrical, zoning, fire-safety and municipal requirements.
If electric baseboard heating forms part of the approved project design, confirm heating load, voltage, wattage, circuit capacity, clearances and installation requirements before ordering.
Owen Sound ARU considerations
- Confirm zoning and dwelling-type eligibility for the property
- Confirm the project stays within the two-ARU-per-lot limit
- Only one ARU may be located in an accessory building
- Obtain the required building permit before construction
- Review servicing, parking and site-specific requirements
- Match heater voltage and wattage to the approved electrical and heating design
Built-in temperature control
Complete the Brava installation with a Stelpro thermostat.
MarsLED stocks both built-in mechanical thermostat options. Compatibility and the correct control type should be confirmed for the specific heater and project before installation.
Single-Pole Built-In Thermostat
Mechanical 120–600 V built-in temperature control for compatible Stelpro baseboard heater installations.
View SIBT1WDouble-Pole Built-In Thermostat
Mechanical 120–600 V double-pole built-in thermostat for compatible Stelpro baseboard heater installations.
View SIBT2WOwen Sound product questions
Stelpro baseboard heater FAQ — Owen Sound
Where can I buy Stelpro Brava baseboard heaters for an Owen Sound project?
MarsLED stocks multiple Stelpro Brava 120 V and 240/208 V electric baseboard heaters for Owen Sound homeowners, contractors, electricians, landlords and property-management customers.
What heating capability does Owen Sound's Property Standards By-law require?
Owen Sound requires every dwelling to have a heating system capable of maintaining 20°C in habitable rooms, bathrooms and toilet rooms when the outdoor temperature is -21°C, using the measurement conditions specified in the by-law.
What temperature applies to landlord-provided heat in Owen Sound rental accommodation?
Owen Sound's Heat By-law defines adequate landlord-provided heat as an air temperature consistently not less than 21°C from September 15 through May 31 where the landlord is normally responsible for providing heat.
What terminology does Owen Sound use for secondary residential units?
Owen Sound uses the term Additional Residential Unit, or ARU.
How many ARUs can be permitted on an Owen Sound lot?
Owen Sound's current framework permits a maximum of two ARUs per qualifying lot, subject to applicable zoning and property requirements.
Can an Owen Sound ARU be located in an accessory building?
Yes. A maximum of one ARU may be located in an accessory building on a qualifying lot, subject to applicable zoning and building requirements.
What types of ARU configurations does Owen Sound recognize?
The City's ARU guidance illustrates configurations including basement apartments, units incorporated into or added to the primary dwelling and units in detached accessory structures.
Does an Owen Sound ARU require a building permit?
Yes. Owen Sound requires a building permit for an Additional Residential Unit, and the project must satisfy applicable Building Code, electrical, zoning and other requirements.
Are heating calculations relevant to Owen Sound residential permit applications?
Yes. Owen Sound's Building Division identifies heat-loss and heat-gain calculations among the documentation required for major residential construction and renovation permit applications.
Can I replace an old baseboard heater with a Brava model of the same wattage?
Not automatically. Confirm voltage, circuit requirements, calculated heating load, dimensions, clearances and installation requirements before choosing a replacement.
Should I buy a 120 V or 240 V baseboard heater?
The heater voltage must match the electrical design of the project. Confirm the existing circuit or project requirements before ordering.
Does MarsLED supply Stelpro heaters for contractor and property-management projects in Owen Sound?
Yes. MarsLED's stocked Brava portfolio is available for residential, renovation, rental-property, contractor and property-management projects in Owen Sound and Grey County, subject to product availability.
Can a built-in thermostat be added to a Stelpro Brava heater?
Compatible Brava installations can use optional built-in thermostat controls. MarsLED stocks the Stelpro SIBT1W single-pole and SIBT2W double-pole thermostat options.
Shop Stelpro Brava heaters for Owen Sound projects.
Compare stocked wattages, voltages and thermostat options from MarsLED.