Stelpro Electric Baseboard Heaters Etobicoke, Ontario
Stelpro Brava In Stock at MarsLED
Etobicoke, Ontario • Electric Heating
Stelpro Electric Baseboard Heaters in Etobicoke
Shop stocked Stelpro Brava electric baseboard heaters for Etobicoke homes, rental properties, additional dwelling units, basement renovations, contractor projects and property-management applications. MarsLED carries 120 V and 240/208 V Brava models plus compatible built-in thermostat options.
Stelpro Brava Etobicoke
Electric baseboard heating for Etobicoke homes and projects.
Electric baseboard heating can be a practical option in Etobicoke homes, rental units, additional dwelling units and renovation projects where the electrical and heating design calls for electric resistance heat. Stelpro Brava heaters provide multiple wattage and voltage configurations for project-specific selection.
Stelpro identifies Brava for bedrooms, dining rooms, living rooms and offices. Its rounded corners, one-piece rugged casing and installer-friendly design also make the platform useful for replacement work and ongoing property maintenance.
Why Brava?
Brava combines low-profile electric convection heat with the durability and clean appearance needed for residential and appropriate light-commercial environments.
- Rounded-corner design
- Rugged one-piece steel casing
- Quiet heating-element design
- Multiple wattage and voltage options
- Optional built-in thermostat control
Etobicoke / Toronto rental-heating context
Toronto requires 21°C in landlord-heated rental units from October 1 to May 15.
Etobicoke is part of the City of Toronto. Under Toronto's current Indoor Temperature Standards By-law, every landlord who normally provides heat at the landlord's expense must maintain a minimum air temperature of 21°C in all areas of a rented dwelling unit from October 1 through May 15.
The 21°C temperature is measured 1.5 metres above floor level. Where a rented dwelling unit is already at least 21°C, the landlord is not required to operate the heating unit. For electrically heated Etobicoke properties, permanent baseboard heating can support replacement and renovation work where voltage, wattage, circuit capacity, clearances and calculated heating requirements are properly confirmed.
Stocked at MarsLED
Compare Stelpro Brava baseboard heaters.
Choose from the stocked MarsLED Brava range below. Heater selection should be based on the project's calculated heating load, voltage, circuit requirements, dimensions, clearances and applicable electrical requirements—not wattage or room size alone.
| Model | Power | Voltage | Length | Shop |
|---|---|---|---|---|
| B0501W | 500 W | 120 V | 27-7/8" | View B0501W |
| B0751W | 750 W | 120 V | 37-5/8" | View B0751W |
| B1001W | 1000 W | 120 V | 47-1/2" | View B1001W |
| B0502W | 500 / 375 W | 240 / 208 V | 27-7/8" | View B0502W |
| B0752W | 750 / 560 W | 240 / 208 V | 37-5/8" | View B0752W |
| B1002W | 1000 / 750 W | 240 / 208 V | 47-1/2" | View B1002W |
| B1502W | 1500 / 1125 W | 240 / 208 V | 66-1/4" | View B1502W |
| B2002W | 2000 / 1500 W | 240 / 208 V | 83-7/8" | View B2002W |
Electrical selection
120 V or 240/208 V? Match the heater to the project.
Voltage must match the electrical design and circuit serving the heater. When replacing an existing baseboard or planning a new installation, confirm voltage, wattage, circuit capacity and installation conditions before ordering.
B0501W • B0751W • B1001W
MarsLED stocks three 120 V Brava models from 500 W through 1000 W for projects designed around 120 V electric baseboard heating.
500 W through 2000 W
The stocked 240/208 V Brava range includes five models. Output is lower at 208 V, so both ratings are shown on the individual product pages.
Etobicoke application guide
Where Brava fits into Etobicoke projects.
Brava heaters can support a wide range of projects when electric resistance baseboard heat is appropriate for the building and the heater is correctly specified.
Replacement or new electric heating in bedrooms, living areas, offices, basements and additions.
Heating for permitted secondary-suite, multiplex, garden-suite or other approved Etobicoke projects where electric baseboard heat forms part of the electrical and heating design.
Replacement and maintenance work in electrically heated rented residential units.
Stocked heater options for ongoing building maintenance, renovation and replacement programs.
Multiple wattage and voltage options for properly specified installation and retrofit work.
A familiar electric-heating platform for renovation, addition and residential construction projects.
Additional dwelling units in Etobicoke
Toronto's city-wide zoning permits multiplexes with up to four dwelling units in residential zones.
Etobicoke follows City of Toronto zoning and building-permit requirements. Toronto's multiplex framework permits duplexes, triplexes and fourplexes in residential R, RD, RS, RM and RT zones, subject to the zoning standards and property-specific requirements. Existing houses may also be converted to contain two, three or four dwelling units where the applicable requirements are met.
Toronto continues to use Secondary Suite terminology for additional living accommodation located within and subordinate to a dwelling unit in a detached house, semi-detached house or townhouse. Buildings containing up to four independent dwelling units are generally treated as multiplexes.
Detached additional housing is also possible through garden suites and, where a property has qualifying laneway conditions, laneway suites. A garden suite is a separate self-contained living accommodation generally located in the rear yard and requires a building permit, Ontario Building Code compliance, zoning compliance and appropriate fire access.
Toronto also offers pre-approved garden and laneway suite plans to streamline permit applications, but site-specific review and a building permit are still required. If electric baseboard heating forms part of an approved Etobicoke project design, confirm heating load, voltage, wattage, circuit capacity, clearances and installation requirements before ordering.
Etobicoke / Toronto housing considerations
- Confirm the property's zoning through Toronto's zoning map
- Confirm whether the project is a secondary suite, multiplex conversion, garden suite or laneway suite
- Multiplexes with up to four units are permitted in qualifying residential zones
- Obtain the required Toronto building permit before construction
- Confirm Ontario Building Code, zoning, fire-access and site-specific requirements
- Match heater voltage and wattage to the approved electrical and heating design
Built-in temperature control
Complete the Brava installation with a Stelpro thermostat.
MarsLED stocks both built-in mechanical thermostat options. Compatibility and the correct control type should be confirmed for the specific heater and project before installation.
Single-Pole Built-In Thermostat
Mechanical 120–600 V built-in temperature control for compatible Stelpro baseboard heater installations.
View SIBT1WDouble-Pole Built-In Thermostat
Mechanical 120–600 V double-pole built-in thermostat for compatible Stelpro baseboard heater installations.
View SIBT2WEtobicoke product questions
Stelpro baseboard heater FAQ — Etobicoke
Where can I buy Stelpro Brava baseboard heaters for an Etobicoke project?
MarsLED stocks multiple Stelpro Brava 120 V and 240/208 V electric baseboard heaters for Etobicoke homeowners, contractors, electricians, landlords and property-management customers.
What minimum temperature does Toronto require in landlord-heated rental units?
Toronto's current Indoor Temperature Standards By-law requires landlords who normally provide heat at their expense to maintain at least 21°C from October 1 through May 15.
Does the Toronto heating requirement apply when the rental unit is already 21°C without operating the heat?
No additional heating operation is required where the rented dwelling unit is already at a minimum air temperature of 21°C.
What housing rules apply to Etobicoke?
Etobicoke is part of the City of Toronto, so Toronto's city-wide zoning, building-permit and property-standards requirements apply.
How many units can a Toronto multiplex contain?
Toronto defines multiplexes as residential buildings containing two, three or four dwelling units, commonly called duplexes, triplexes and fourplexes.
Where does Toronto permit duplexes, triplexes and fourplexes?
Toronto permits these multiplex building types in qualifying R, RD, RS, RM and RT residential zones, subject to applicable zoning and property-specific requirements.
Can an existing Etobicoke house be converted into a multiplex?
Yes. Toronto's current framework allows qualifying existing houses to be converted to contain two, three or four dwelling units where applicable requirements are met.
What does Toronto mean by a secondary suite?
A secondary suite is additional living accommodation located within and subordinate to a dwelling unit in a detached house, semi-detached house or townhouse.
Can an Etobicoke property have a garden suite?
Potentially. Toronto permits qualifying garden suites as separate self-contained living accommodation generally located in the rear yard, subject to zoning, Building Code, fire-access and permit requirements.
Does Toronto offer pre-approved garden or laneway suite plans?
Yes. Toronto offers pre-approved garden and laneway suite plans to help streamline applications, although site-specific review and a building permit are still required.
Does an Etobicoke multiplex or garden suite require a building permit?
Yes. Toronto provides specific building-permit application processes for multiplex conversions, secondary suites, garden suites and laneway suites.
Can I replace an old baseboard heater with a Brava model of the same wattage?
Not automatically. Confirm voltage, circuit requirements, calculated heating load, dimensions, clearances and installation requirements before choosing a replacement.
Should I buy a 120 V or 240 V baseboard heater?
The heater voltage must match the electrical design of the project. Confirm the existing circuit or project requirements before ordering.
Does MarsLED supply Stelpro heaters for contractor and property-management projects in Etobicoke?
Yes. MarsLED's stocked Brava portfolio is available for residential, renovation, rental-property, contractor and property-management projects in Etobicoke and Toronto, subject to product availability.
Can a built-in thermostat be added to a Stelpro Brava heater?
Compatible Brava installations can use optional built-in thermostat controls. MarsLED stocks the Stelpro SIBT1W single-pole and SIBT2W double-pole thermostat options.
Shop Stelpro Brava heaters for Etobicoke projects.
Compare stocked wattages, voltages and thermostat options from MarsLED.