Stelpro Electric Baseboard Heaters Collingwood, Ontario
Stelpro Brava In Stock at MarsLED
Collingwood, Ontario • Electric Heating
Stelpro Electric Baseboard Heaters in Collingwood
Shop stocked Stelpro Brava electric baseboard heaters for Collingwood homes, rental properties, additional residential units, basement renovations, contractor projects and property-management applications. MarsLED carries 120 V and 240/208 V Brava models plus compatible built-in thermostat options.
Stelpro Brava Collingwood
Electric baseboard heating for Collingwood homes and projects.
Electric baseboard heating can be a practical option in Collingwood homes, rental units, additional residential units and renovation projects where the electrical and heating design calls for electric resistance heat. Stelpro Brava heaters provide multiple wattage and voltage configurations for project-specific selection.
Stelpro identifies Brava for bedrooms, dining rooms, living rooms and offices. Its rounded corners, one-piece rugged casing and installer-friendly design also make the platform useful for replacement work and ongoing property maintenance.
Why Brava?
Brava combines low-profile electric convection heat with the durability and clean appearance needed for residential and appropriate light-commercial environments.
- Rounded-corner design
- Rugged one-piece steel casing
- Quiet heating-element design
- Multiple wattage and voltage options
- Optional built-in thermostat control
Collingwood property-standards context
Collingwood requires 22°C in habitable spaces and unfinished basements during its heating season.
Collingwood's Property Standards By-law requires every dwelling to have a heating system capable of continuously maintaining at least 22°C in all habitable rooms and interior living spaces, including unfinished basement spaces. Heated crawlspaces must be capable of maintaining at least 15°C.
The by-law applies these indoor-air temperature requirements from September 15 through May 31 unless otherwise specified by the Chief Building Official. Electrical wiring and fixtures must also be installed and maintained in good working order in conformity with Ontario Electrical Safety Authority requirements. For electrically heated properties, properly specified permanent baseboard heaters can therefore support replacement, renovation and rental-property maintenance work.
Stocked at MarsLED
Compare Stelpro Brava baseboard heaters.
Choose from the stocked MarsLED Brava range below. Heater selection should be based on the project's calculated heating load, voltage, circuit requirements, dimensions, clearances and applicable electrical requirements—not wattage or room size alone.
| Model | Power | Voltage | Length | Shop |
|---|---|---|---|---|
| B0501W | 500 W | 120 V | 27-7/8" | View B0501W |
| B0751W | 750 W | 120 V | 37-5/8" | View B0751W |
| B1001W | 1000 W | 120 V | 47-1/2" | View B1001W |
| B0502W | 500 / 375 W | 240 / 208 V | 27-7/8" | View B0502W |
| B0752W | 750 / 560 W | 240 / 208 V | 37-5/8" | View B0752W |
| B1002W | 1000 / 750 W | 240 / 208 V | 47-1/2" | View B1002W |
| B1502W | 1500 / 1125 W | 240 / 208 V | 66-1/4" | View B1502W |
| B2002W | 2000 / 1500 W | 240 / 208 V | 83-7/8" | View B2002W |
Electrical selection
120 V or 240/208 V? Match the heater to the project.
Voltage must match the electrical design and circuit serving the heater. When replacing an existing baseboard or planning a new installation, confirm voltage, wattage, circuit capacity and installation conditions before ordering.
B0501W • B0751W • B1001W
MarsLED stocks three 120 V Brava models from 500 W through 1000 W for projects designed around 120 V electric baseboard heating.
500 W through 2000 W
The stocked 240/208 V Brava range includes five models. Output is lower at 208 V, so both ratings are shown on the individual product pages.
Collingwood application guide
Where Brava fits into Collingwood projects.
Brava heaters can support a wide range of projects when electric resistance baseboard heat is appropriate for the building and the heater is correctly specified.
Replacement or new electric heating in bedrooms, living areas, offices, basements and additions.
Heating for permitted basement, interior, above-garage or detached coach-house ARU projects where electric baseboard heat is part of the approved electrical and heating design.
Replacement and maintenance work in electrically heated rented residential units.
Stocked heater options for ongoing building maintenance, renovation and replacement programs.
Multiple wattage and voltage options for properly specified installation and retrofit work.
A familiar electric-heating platform for renovation, addition and residential construction projects.
Additional residential units in Collingwood
Collingwood now allows up to four dwelling units on qualifying serviced residential and rural lots.
Collingwood uses the term Additional Residential Unit (ARU) for a smaller self-contained living unit located within the main dwelling or separately on the same property. Examples include basement apartments, dwelling units above garages and detached coach houses.
Through its Rapid ARU Initiative 2.0 and current zoning updates, the Town allows up to four dwelling units on qualifying serviced residential and rural lots, subject to the applicable zoning provisions. The Town has also reduced parking requirements for ARUs and provides pre-approved designs intended to simplify project planning.
A building permit is required before construction. Collingwood's current 2026 Rapid ARU program also offers financial incentives: eligible participants who receive zoning-certificate and building-permit approval and agree to rent the unit year-round for at least five years may receive a $10,000 grant, subject to program funding and eligibility.
If electric baseboard heating forms part of the approved project design, confirm heating load, voltage, wattage, circuit capacity, clearances and installation requirements before ordering.
Collingwood ARU considerations
- Confirm zoning and servicing eligibility for the property
- Confirm the proposed configuration stays within the four-unit total
- Obtain zoning-certificate and building-permit approvals before construction
- Review parking, setbacks and accessory-building requirements
- Check current Rapid ARU grant eligibility before relying on incentive funding
- Match heater voltage and wattage to the approved electrical and heating design
Built-in temperature control
Complete the Brava installation with a Stelpro thermostat.
MarsLED stocks both built-in mechanical thermostat options. Compatibility and the correct control type should be confirmed for the specific heater and project before installation.
Single-Pole Built-In Thermostat
Mechanical 120–600 V built-in temperature control for compatible Stelpro baseboard heater installations.
View SIBT1WDouble-Pole Built-In Thermostat
Mechanical 120–600 V double-pole built-in thermostat for compatible Stelpro baseboard heater installations.
View SIBT2WCollingwood product questions
Stelpro baseboard heater FAQ — Collingwood
Where can I buy Stelpro Brava baseboard heaters for a Collingwood project?
MarsLED stocks multiple Stelpro Brava 120 V and 240/208 V electric baseboard heaters for Collingwood homeowners, contractors, electricians, landlords and property-management customers.
What minimum heating capability does Collingwood require in dwellings?
Collingwood's Property Standards By-law requires heating systems capable of maintaining at least 22°C in habitable rooms, interior living spaces and unfinished basements, and 15°C in heated crawlspaces.
When does Collingwood's heating-season requirement apply?
The current Property Standards By-law applies the specified indoor-air temperature requirements from September 15 through May 31 unless otherwise specified by the Chief Building Official.
What terminology does Collingwood use for secondary residential units?
Collingwood uses the term Additional Residential Unit, or ARU.
How many dwelling units can be permitted on a qualifying Collingwood property?
Collingwood's current zoning updates allow up to four dwelling units on qualifying serviced residential and rural lots, subject to applicable zoning requirements.
What types of ARUs does Collingwood recognize?
Collingwood identifies examples including basement apartments, units above garages and detached coach houses.
Does Collingwood offer pre-approved ARU designs?
Yes. The Town's Rapid ARU Initiative includes pre-approved designs intended to simplify planning and permitting, although site-specific zoning and permit requirements still apply.
Does a Collingwood ARU require a building permit?
Yes. A building permit is required, and property owners should confirm zoning and servicing requirements before construction.
Is there a Collingwood ARU grant available in 2026?
Yes. Collingwood's 2026 Rapid ARU program offers a $10,000 grant to eligible participants who receive zoning-certificate and building-permit approval and agree to rent the unit year-round for at least five years, subject to available funding and program requirements.
Can I replace an old baseboard heater with a Brava model of the same wattage?
Not automatically. Confirm voltage, circuit requirements, calculated heating load, dimensions, clearances and installation requirements before choosing a replacement.
Should I buy a 120 V or 240 V baseboard heater?
The heater voltage must match the electrical design of the project. Confirm the existing circuit or project requirements before ordering.
Does MarsLED supply Stelpro heaters for contractor and property-management projects in Collingwood?
Yes. MarsLED's stocked Brava portfolio is available for residential, renovation, rental-property, contractor and property-management projects in Collingwood and South Georgian Bay, subject to product availability.
Can a built-in thermostat be added to a Stelpro Brava heater?
Compatible Brava installations can use optional built-in thermostat controls. MarsLED stocks the Stelpro SIBT1W single-pole and SIBT2W double-pole thermostat options.
Shop Stelpro Brava heaters for Collingwood projects.
Compare stocked wattages, voltages and thermostat options from MarsLED.
