Stelpro Electric Baseboard Heaters Aurora, Ontario
Stelpro Brava In Stock at MarsLED
Aurora, Ontario • Electric Heating
Stelpro Electric Baseboard Heaters in Aurora
Shop stocked Stelpro Brava electric baseboard heaters for Aurora homes, rental properties, additional residential units, basement renovations, contractor projects and property-management applications. MarsLED carries 120 V and 240/208 V Brava models plus compatible built-in thermostat options.
Stelpro Brava Aurora
Electric baseboard heating for Aurora homes and projects.
Electric baseboard heating can be a practical option in Aurora homes, rental units, additional residential units and renovation projects where the electrical and heating design calls for electric resistance heat. Stelpro Brava heaters provide multiple wattage and voltage configurations for project-specific selection.
Stelpro identifies Brava for bedrooms, dining rooms, living rooms and offices. Its rounded corners, one-piece rugged casing and installer-friendly design also make the platform useful for replacement work and ongoing property maintenance.
Why Brava?
Brava combines low-profile electric convection heat with the durability and clean appearance needed for residential and appropriate light-commercial environments.
- Rounded-corner design
- Rugged one-piece steel casing
- Quiet heating-element design
- Multiple wattage and voltage options
- Optional built-in thermostat control
Aurora property-standards context
Aurora requires permanent dwelling heating systems capable of maintaining 20°C.
Aurora's current Property Standards By-law requires every dwelling to have a permanent heating system capable of maintaining a room temperature of 20°C in all habitable rooms, bathrooms and washrooms. The temperature is measured 1.5 metres above floor level and one metre from exterior walls.
The heating system must be maintained in good working condition so the dwelling can be heated safely to the required temperature. Aurora's Vital Services By-law separately requires landlords to provide a minimum temperature of 20°C between September 15 and June 1 in rental dwellings where heat is a vital service.
Stocked at MarsLED
Compare Stelpro Brava baseboard heaters.
Choose from the stocked MarsLED Brava range below. Heater selection should be based on the project's calculated heating load, voltage, circuit requirements, dimensions, clearances and applicable electrical requirements—not wattage or room size alone.
| Model | Power | Voltage | Length | Shop |
|---|---|---|---|---|
| B0501W | 500 W | 120 V | 27-7/8" | View B0501W |
| B0751W | 750 W | 120 V | 37-5/8" | View B0751W |
| B1001W | 1000 W | 120 V | 47-1/2" | View B1001W |
| B0502W | 500 / 375 W | 240 / 208 V | 27-7/8" | View B0502W |
| B0752W | 750 / 560 W | 240 / 208 V | 37-5/8" | View B0752W |
| B1002W | 1000 / 750 W | 240 / 208 V | 47-1/2" | View B1002W |
| B1502W | 1500 / 1125 W | 240 / 208 V | 66-1/4" | View B1502W |
| B2002W | 2000 / 1500 W | 240 / 208 V | 83-7/8" | View B2002W |
Electrical selection
120 V or 240/208 V? Match the heater to the project.
Voltage must match the electrical design and circuit serving the heater. When replacing an existing baseboard or planning a new installation, confirm voltage, wattage, circuit capacity and installation conditions before ordering.
B0501W • B0751W • B1001W
MarsLED stocks three 120 V Brava models from 500 W through 1000 W for projects designed around 120 V electric baseboard heating.
500 W through 2000 W
The stocked 240/208 V Brava range includes five models. Output is lower at 208 V, so both ratings are shown on the individual product pages.
Aurora application guide
Where Brava fits into Aurora projects.
Brava heaters can support a wide range of projects when electric resistance baseboard heat is appropriate for the building and the heater is correctly specified.
Replacement or new electric heating in bedrooms, living areas, offices, basements and additions.
Heating for permitted basement, interior, attached or accessory-structure ARU projects where electric baseboard heat is part of the approved electrical and heating design.
Replacement and maintenance work in electrically heated rented residential units.
Stocked heater options for ongoing building maintenance, renovation and replacement programs.
Multiple wattage and voltage options for properly specified installation and retrofit work.
A familiar electric-heating platform for renovation, addition and residential construction projects.
Additional residential units in Aurora
Aurora permits two ARUs in addition to the primary dwelling, creating up to three residential units per lot.
Aurora uses the term Additional Residential Unit (ARU). Registration By-law 6660-24 replaced the Town's former second-suite registration framework and expanded registration to two ARUs associated with a qualifying single-family residential property.
The Town's current registration framework supports ARUs within detached, semi-detached and townhouse dwellings and within an accessory structure on the same property. This has the effect of allowing up to three residential units per qualifying lot: the primary dwelling plus two ARUs, subject to applicable zoning, servicing and property-specific requirements.
Aurora requires ARUs to be registered. The registration framework includes inspection and compliance provisions, and ARU projects must satisfy applicable Ontario Building Code, Fire Code, zoning, electrical and municipal requirements.
Aurora's 2026 Downtown Community Planning Permit By-law also reflects the two-ARU framework in its applicable downtown residential provisions and requires municipal sanitary and water servicing for ARUs in that area. If electric baseboard heating forms part of an approved project design, confirm heating load, voltage, wattage, circuit capacity, clearances and installation requirements before ordering.
Aurora ARU considerations
- Confirm dwelling type and zoning eligibility
- Confirm the project stays within the two-ARU / three-total-unit framework
- Confirm whether an ARU is inside the principal dwelling or in an accessory structure
- Obtain required building approvals and inspections
- Complete the Town's ARU registration requirements
- Match heater voltage and wattage to the approved electrical and heating design
Built-in temperature control
Complete the Brava installation with a Stelpro thermostat.
MarsLED stocks both built-in mechanical thermostat options. Compatibility and the correct control type should be confirmed for the specific heater and project before installation.
Single-Pole Built-In Thermostat
Mechanical 120–600 V built-in temperature control for compatible Stelpro baseboard heater installations.
View SIBT1WDouble-Pole Built-In Thermostat
Mechanical 120–600 V double-pole built-in thermostat for compatible Stelpro baseboard heater installations.
View SIBT2WAurora product questions
Stelpro baseboard heater FAQ — Aurora
Where can I buy Stelpro Brava baseboard heaters for an Aurora project?
MarsLED stocks multiple Stelpro Brava 120 V and 240/208 V electric baseboard heaters for Aurora homeowners, contractors, electricians, landlords and property-management customers.
What minimum heating capability does Aurora require in dwellings?
Aurora's Property Standards By-law requires every dwelling to have a permanent heating system capable of maintaining 20°C in habitable rooms, bathrooms and washrooms.
What rental-heating temperature does Aurora require under its Vital Services rules?
Aurora requires landlords to provide a minimum temperature of 20°C between September 15 and June 1 in rental dwellings where heat is a vital service.
How must heating systems be maintained in Aurora?
Aurora requires permanent heating systems to be maintained in good working condition so dwellings can be heated safely to the required temperature.
What terminology does Aurora use for secondary residential units?
Aurora uses the term Additional Residential Unit, or ARU.
How many ARUs can be associated with a qualifying Aurora property?
Aurora's current registration framework provides for two ARUs associated with a qualifying primary dwelling, creating up to three residential units on the lot.
What dwelling types can support ARUs in Aurora?
Aurora's current registration framework supports ARUs in detached, semi-detached and townhouse dwellings, subject to zoning and property-specific requirements.
Can an Aurora ARU be located in an accessory structure?
Yes. Aurora's current framework includes ARUs located within an accessory structure on the same property, subject to applicable zoning and building requirements.
Do Aurora ARUs have to be registered?
Yes. By-law 6660-24 requires the registration of Additional Residential Units and includes inspection and compliance provisions.
What standards apply to an Aurora ARU?
ARU projects must satisfy applicable Ontario Building Code, Fire Code, zoning, electrical and municipal requirements.
Does Aurora's 2026 downtown planning framework address ARUs?
Yes. Aurora's Downtown Community Planning Permit By-law includes provisions for up to two ARUs in applicable downtown residential situations and requires municipal sanitary and water servicing.
Can I replace an old baseboard heater with a Brava model of the same wattage?
Not automatically. Confirm voltage, circuit requirements, calculated heating load, dimensions, clearances and installation requirements before choosing a replacement.
Should I buy a 120 V or 240 V baseboard heater?
The heater voltage must match the electrical design of the project. Confirm the existing circuit or project requirements before ordering.
Does MarsLED supply Stelpro heaters for contractor and property-management projects in Aurora?
Yes. MarsLED's stocked Brava portfolio is available for residential, renovation, rental-property, contractor and property-management projects in Aurora and York Region, subject to product availability.
Can a built-in thermostat be added to a Stelpro Brava heater?
Compatible Brava installations can use optional built-in thermostat controls. MarsLED stocks the Stelpro SIBT1W single-pole and SIBT2W double-pole thermostat options.
Shop Stelpro Brava heaters for Aurora projects.
Compare stocked wattages, voltages and thermostat options from MarsLED.